Manager can be used to create a new configuration without connecting to an IP Office system. During the process, you can specify the locale of the system, what type of trunk cards it uses and what type of control unit and expansion modules to include.
This allows the creation of a configuration prior to installation of the real system and so can be used to speed up installation.
The configuration created must match the physical equipment in the IP Office system onto which the configuration will be loaded. Doing otherwise may cause the IP Office system to reset and experience other problems.
The Create Configuration tool includes all control units, external expansion modules and trunk cards supported by IP Office. It is you responsibility to confirm what IP Office equipment is supported in your locale.
Creating a New Configuration
Click in the main toolbar or select File | Offline | Create New Config from the menu bar.
Select the Locale for the system. This defines a range of features such as default telephony settings. Click Next >.
Select the type of IP Office control unit. Then select the expansion modules, excluding WAN3, to also include in the system. Click Next >.
Select the trunks cards to be included and the IP address of a WAN3 module if required. Click Finish.
The configuration is created and loaded into Manager.
Once this configuration has been edited as required it can be saved on the PC. In order to send it to the matching IP Office system, File | Offline | Send Configuration has to be used.
in the main toolbar or select 
