E1-R2 PRI trunks are provided by the installation of an E1-R2 PRI trunk card into the IP Office control unit. E1-R2 PRI trunk cards are not supported with the IP Office Small Office Edition control unit. Dual port E1-R2 PRI trunk cards are only supported with the IP412 control unit and in Slot A of the IP406 V2 control unit. These trunk cards are available in RJ45 connector or coaxial connector versions. For full details of installation refer to the IP Office Installation manual.
Each physical E1 PRI trunk port supports up to 30 channels for calls.
Trunk Cards
Small
Office
IP403
IP406 V1
IP406 V2
IP412
Channels
per
Trunk
Signaling
Modes
Slots
A
A
B
A
B
A
B
A
B
Single PRI E1-R2
Provides a single E1-R2 trunk.
30
E1-R2
ETSI
QSIG
Dual PRI E1R2
Provides two E1-R2 trunks.
Incoming Call Routing: Analog, T1, T1 ISDN and E1R2 Trunks
The following options are used to route incoming calls received on this type of trunk.
Incoming Call Route
Based on matching the Incoming Line Group plus if set the incoming number and or ICLID.
System Short Code
The IP Office checks for a short code match based on the incoming number.
Voicemail Match
The IP Office checks for a call flow start point name matching the incoming number.
Line | Line (E1-R2)
Settings
Action
Operator Rights View
Mergeable
System
Level
Administrator
Manager
Operator
SOE
2.1
View
Pre-3.2
3.2
IP403
3.0DT
Edit
IP406 V1
3.0
New
IP406 V2
3.1
Delete
IP412
3.2
Line Number:
Allocated by the system.
Line SubType:Default = E1-R2
Supported options are E1-R2, ETSI, QSIGA or QSIGB.
Channel Allocation:Default = 30 -> 1
The order, 30 -> 1 or 1 -> 30, in which channels are used.
Country (Locale):Default = Mexico.
Select the locale that matches the area of usage. Note that changing the locale will return the MFC Group settings to the defaults for the selected locale. Currently supported locales Argentina, Brazil, China, India, Korea, Mexico and None.
The table at the base of the form displays the settings for the individual channels provided by the line. For details of the channel settings see Edit Channel (E1-R2).
To edit a channel, either double-click on it or right-click and select Edit. This will display the Edit Channel dialog box. To edit multiple channels at the same time select the channels whilst pressing the Shift or Ctrl key. Then right-click and select Edit.
