Channel
Allocated by the system.
Incoming Group ID: Default = 0, Range 0 to 99999.
The Incoming Group ID to which a line belongs is used to match it to incoming call routes in the IP Office configuration. The matching incoming call route is then used to route incoming calls. The same ID can be used for multiple lines.
Outgoing Group ID: Default = 0, Range 0 to 99999.
Short codes that specify a number to dial also specify the line group to be used. The IP Office will then seize a line with a matching Outgoing Group ID. The same ID can be used for multiple lines.
Line Appearance ID: Default = Blank, Range = 2 to 9 digits.
[2.1 
][3.0DT ][3.0 
][3.1 ][3.2 ]
Used for configuring Line Appearances with button programming. The line appearance ID must be unique and not match any extension number.
Direction: Default = Both Directions
The direction of calls on the channel (Incoming, Outgoing or Both Directions).
Bearer: Default = Any
The type of traffic carried by the channel (Voice, Data or Any).
Service: Default = No Service or None.
If the line provider is set to AT&T, selects the type of service provided by the channel from Call by Call,SDN (inc GSDN),MegaCom800,MegaComWats, Accunet,NLDS,I800,ETN,Private Line,AT&T Multiquest. For other providers the service options are None or No Service.
Admin: Default = In Service
Used to indicate the channel status (In Service, Out of Service or Maintenance).
Tx Gain: Default = 0dB
The transmit gain in dB.
Rx Gain: Default = 0dB
The receive gain in dB.
