Line | Special (T1 PRI)

This tab is shown when the line Provider is set to AT&T. This table is used to set additional fields in the NSF information element after initial number parsing by the TNS tab. These are used to indicate the services required by the call. If the channel is set to Call by Call, then further parsing is done using the entries in the Call by Call tab.

Settings

Action	Operator Rights View			Mergeable		System	Level
Action	Administrator	Manager	Operator	Mergeable		SOE	2.1
View				Pre-3.2	3.2	IP403	3.0DT
Edit						IP406 V1	3.0
New						IP406 V2	3.1
Delete						IP412	3.2

Short code:
The number which results from the application of the rules specified in the User or System Short code tables and the Network Selection table and the Call-by-call table to the number dialed by the user.

Number:
The number to be dialed to line.

Special: Default = No Operator
(No Operator, Local Operator or Presubscribed Operator).

Plan: Default = National
(National or International).

Typical values would be:

Short code	Number	Service
011N	N	No Operator, International
010N	N	Local Operator, International
01N	N	Local Operator, National
00N	N	Presubscribed Operator, National
0N	N	Presubscribed Operator, National
1N	1N	No operator, National

Line | Call By Call (T1 PRI)

This tab is shown when the line Provider is set to AT&T. Settings in this tab are only used when calls are routed via a channel which has its Service set to Call by Call.

It allows short codes to be created to route calls to a different services according to the number dialed. Call By Call reduces the costs and maximizes the use of facilities. Call By Call chooses the optimal service for a particular call by including the Bearer capability in the routing decision. This is particularly useful when there are limited resources.

Settings

Action	Operator Rights View			Mergeable		System	Level
Action	Administrator	Manager	Operator	Mergeable		SOE	2.1
View				Pre-3.2	3.2	IP403	3.0DT
Edit						IP406 V1	3.0
New						IP406 V2	3.1
Delete						IP412	3.2

Short Code:
The number which results from the application of the rules specified in the User or System Short code tables and the Network Selection table to the number dialed by the user.
Number:
The number to be dialed to line.
Bearer: Default = Any
The type of channel required for the call (Voice, Data or Any).
Service: Default = AT&T.99
The service required by the call (SDN (inc GSDN),MegaCom800,MegaCom,Inwats,Wats, Accunet,NLDS,I800,ETN,Private Line,AT&T Multiquest).